Catenary hardware, UV-stabilized fixings, IP68 connectors and the MaxiLINK data-over-power controller — the parts that turn a run of MaxiLED luminaires into a finished installation. Every item carries its own MaxiLED product code and datasheet.
Split nitrile grommet that protects the drop cable where it passes through a metal catenary plate or panel. Must be split before use.
Catenary cable, 6×19 fibre-core galvanised construction, for overhead spans carrying festoon and pendant runs.
Turnbuckles, grips, eye bolts, shackles, thimbles and carabiner hooks — the full set of fixings for anchoring a catenary into masonry and concrete.
PA66W ties to ASTM D6779 with raised carbon content, for outdoor runs with high UV exposure. Used on catenary, tree and surface installations alike.
Ribbed, super-soft PVC ties that support a sapling without cutting the bark, and keep expanding as the tree grows. Silicone-free.
Curved screw-fixing saddle for heavier cable bundles. Secure in high-vibration positions; takes heavy-duty ties up to 6 mm wide.
Takes a DMX-512 signal and mains in, and sends data and 48 VDC out together on a single 2-core cable. Supplied as a fully wired kit with its power supply. One controller per strand.
Constant-voltage transformers for the 24 V MaxiLED platforms, with a wide 120–277 VAC input so the same unit serves European and North American supplies.
Two-pole male/female connector for jointing and terminating low-voltage runs outdoors and in permanently wet positions. Technical data on request.
In-line splice kit for CE wiring, for joints that stay sealed below ground and in permanently wet positions. Contact MaxiLED for technical guidance before use — fitting it unguided may invalidate the warranty.
Terminates the DMX data line after the last fitting on a strand. Without it the run shows data disruption. Adjustable, with a sealed screw cap.
All accessory datasheets are issued in English only. Catenary cable must be installed by a qualified installer.
Every MaxiLED DMX RGBW luminaire is compatible with our patented MaxiLINK protocol — data and power on the same low-voltage cable. The result: no separate DMX bus, no signal cabling overhead, fewer installation faults, lower system cost.
Learn about MaxiLINK →Standard electrical wiring carries both supply and addressable control. No separate DMX bus.
MaxiLINK is MaxiLED-developed and patented. Field-tested across decades of installations.
Fewer cables, simpler terminations, lower contractor risk. The economics work at scale.
Full addressable scene control, dim-to-warm, RGBW programming — without the DMX wiring overhead.
Our team supports lighting designers, architects, municipalities and hospitality groups from specification through commissioning. Get a project-specific quote, photometric files, or product samples from your local MaxiLED specialist.